保洁的开荒程序
Cleaning procedure
开荒是清洁工程之首，由于建筑工程中常常会遗留下许多垃圾污垢，各种地面石头，墙壁上会遗留下水泥浆块、油漆、玻璃胶、水污、锈迹等，这些都必须在开荒工作中清洗干净，所以它是一项最艰苦、最复杂、最费神的工作，开荒工程的好坏，直接影响到日后保洁工作的质量和档次，所以做好开荒有着相当重要的要求。
It is the first of the clean project, because the construction works often leave a lot of trash dirt, all kinds of ground stones, the walls will leave cement paste, paint, glass glue, water pollution, rust and so on. All these must be cleaned in the open work, so it is one of the hardest, most complex and most laborious work. The quality of open wasteland has a direct impact on the quality and grade of cleaning work in the future.
1、 首先清理现场留下的装修垃圾；
1, first clean up the site of the decoration waste;
2、 由上到下全面吸尘；
2, from top to bottom full dust;
3、 擦玻璃：先用毛巾把玻璃框擦拭干净，再用涂水器沾稀释后的玻璃水溶液，均匀的从上到下涂抹玻璃，有顽固的污渍用铲刀清除干净，再重复以上工序后用刮子从上到下刮干净，用干毛巾擦净框上留下的水痕，玻璃上的水痕用机皮擦拭干净。
3, wipe glass: clean the glass frame with a towel first, then dip the dilute glass water solution with the water applicator, evenly spread the glass from top to bottom, clean the stubborn stains with a knife, and then repeat the above process with the scraper from top to bottom, clean the water marks on the frame with dry towels, the water marks on the glass, and the water marks on the glass. Wipe clean with the machine skin.
4、 卫生间：坚持由上而下的原则，首先认清卫生间顶子的材质，是PVC的或是铝塑板还是涂料的，再根据不同的材质用不同的清洁方法进行清洁；用清洁球或是板刷清洗卫生间的墙壁，着重瓷砖的缝隙，和瓷砖表面上遗留的胶迹、涂料点、水泥渍等；用毛巾清洁卫生间的洁具，用不锈钢清洗液针对各种龙头、管件进行清洁；用洗地机对地面进行最后的清洁，由其是地面的边角；最后，检查无遗漏后，再用干毛巾把水龙头等管件擦拭一遍。
4, toilet: adhere to the principle of up and down, first recognize the bathroom ceiling material, is PVC or the aluminum plastic board or paint, and then according to different materials to clean with different cleaning methods; clean the bathroom wall with clean ball or plate brush, focus on tile cracks, and the surface of the tile surface. To clean the toilet with towels, clean the toilet with a stainless steel cleaning liquid, clean the various faucets and fittings with stainless steel cleaning liquid, and clean the ground with the ground washing machine by the washing machine.
5、 厨房：程序同上。注意：因厨房里的不锈钢管件比较多，应是清洁重点。
5, kitchen: the program is same. Attention: because the stainless steel pipe in the kitchen is more, it should be the key of cleanliness.
6、 卧室及大厅：墙壁用掸子做除尘处理，擦拭开关盒等
6. Bedroom and Hall: duster with duster, wipe the switch box, etc.
7、 门及框：分清门的材质，用毛巾擦拭，程序也是从上到下，把毛巾叠成方块，从门的顶部开始从左到右的擦拭，不能有遗漏
7, door and frame: distinguish the material of the door, wipe with a towel, the procedure is also from top to bottom, the towel is folded into square, from the top of the door, the wiping from left to right can not be omitted.
8、 地面的清洗：把所有的做完以后，就是地面的清洗了，地面也要分材质，是木地板的、还是瓷砖的、或是石材的，当分清后就选择专用清洁剂稀释后，开始清洗。地面上的胶渍可用刀片清除，顽固的可用去胶剂处理；最后一道工序做完后，应由领班全面检查一遍后，确认无遗留后撤离现场。
8, ground cleaning: after all the finish, it is the cleaning of the ground, the ground is also to be divided into material, is the wood floor, or tile, or stone, when the separation after the selection of special detergent dilution, start cleaning. The glue stains on the ground can be cleared with the blade, and the stubborn can be treated with the degumming agent. After the last process is finished, it should be checked by the leader in an all-round way to confirm that there is no leave after leaving the site.