灯具的清洁的目标是：清洁后的灯具无灰尘，灯具内无蚊虫，灯盖、灯罩明亮清洁.要达到这个标准，其清洁必须做到：

The goal of the cleaning of lamps and lanterns is: clean lamps without dust, no mosquito inside lamp, lamp cover and lampshade are bright and clean. To achieve this standard, the cleaning must be done:

一、关闭电源，一手托起灯罩，一手拿螺丝刀，拧松灯罩的固定螺丝，取下灯罩.如果是清洁高空的灯具，则架好梯子，人站在梯上作业，但要注意安全，防止摔伤.

First, turn off the power, hand hold the lamp in one hand, a screwdriver, screws loosen the lampshade, take off the cover. If the lamp clean sky, while climbing a ladder, standing on the ladder at work, but to Caution!, to prevent falls.

二、取下灯罩后，用湿抹布擦抹灯罩内外污迹和虫子，再用干抹布抹干水分.

Two. Remove the lampshade, wipe the inside and outside stains and insects with a wet cloth, and then dry the cloth to dry the moisture

三、将灯罩装上，并用螺丝刀拧紧固定螺丝，但不要用力过大，防止损坏灯罩.

Three. Install the lampshade and screw the fastening screw with the screwdriver, but don't force too much to prevent the damage to the lampshade

四、清洁灯管时，也应先关闭电源，打开盖板，取下灯管，用抹布分别擦抹灯管及盖板，然后重新装好.

Four, when cleaning the lamp, it should also turn off the power, open the cover, remove the lamp, wipe the lamp tube and cover plate with the cloth, and then reinstall it